Honey bee colony losses have numbered close to one third of the managed hives for each of the past three years. Still, beekeepers are replacing their lost colonies. The months of February and March are often the harshest for the honey bees. After a long winter’s confinement in the hive, the bees’ stores of food are dwindling. The start-up of the colony’s population puts demand on food supplies in several ways. Brood nests must be warmed to greater temperatures than clusters of bees without brood. The larvae of the increasing population consume large amounts of both honey and pollen. As supplies of food are being depleted, the demand for the food is increasing. This is happening before the great blooms of spring flowers. The earliest sources of nectar and pollen, dandelion, skunk cabbage, and red maple may bloom while the bees are confined to the hive due to cold weather.
Beekeepers will find a number of their colonies have not survived the winter. The cause of the death of the bees is not always apparent. Starvation is probably the most common cause, and it is readily identified. Since the bees share food throughout the colony, the workers can be found with their heads in the cells where they died looking for the last of the food to pass around. If you click on the photo, you can see dead bees on the inner cover of the hive. The presence of drones indicates that this colony probably lost its queen in the fall. Colonies without a queen often retain their drones through the winter. The queen-less colony’s population dwindled till it could no longer warm itself. Other winter losses may occur as the result of infestations of mites or honey bee diseases, like Nosema. Early detection of the loss of the colony allows the beekeeper to protect hive equipment from scavengers, like the wax moths and small hive beetles, and prepare to start a new colony in the spring.
--Richard
Hi Richard, what is the purpose of that small piece of wire mesh over that top entrance notch in the innner cover? Thanks.
ReplyDeleteRuss
Russ,
ReplyDeleteThe two requirements for setting up the hive for the winter are to provide a sufficient supply of honey located where the bees can access it and to provide adequate ventilation. The proper location for the honey is usually directly above the cluster of bees.
I prefer to use hive-top feeders because I have had greater success in controlling small hive beetles when using this type feeder. My experience found small hive beetle larvae apparently thriving on the dead bees in division board feeders, which are located inside the hive. I staple a screen over the vent port on all of my inner covers so that I may use them above hive-top feeders. If the covers are left open, robber bees will enter through the vent and drown in the syrup, inviting small hive beetles. If the covers are removed, as a number of authors suggest, there is no ventilation port at the top of the hive.
This photo shows quite a number of dead bees on the hive’s inner cover. I rarely see this, and I suspect that the workers were attempting to remove the dead of the hive through the screen-blocked port as the colony collapsed. For my hives the screens seem to have worked well. I have not detected any negative effects. If you attempt to use this arrangement, slide the telescoping outer cover so that it opens the vent port on the inner cover. Best wishes.
--Richard